The machine for change of trees Optimal 2000 on the basis of chassis KAMAZ

The machine for change of trees Optimal 2000 on the basis of chassis KAMAZ

The operating cycle consists of the following operations:

— to establish by means of arrow and handle operating part on the earth near the rooted - out tree;

— to involve in turn each lobe of operating part and to open frame;

— to drive up to tree so that at short circuit of frame the tree has appeared on the center of operating part (at the hardly accessible overview to use the assistant operator);

— to close frame and to put forward in turn each lobe of operating part;

— three spring hydraulic cylinders to press earth lump with tree in ladle;

— by means of arrow and handle to put operating part with the rooted - out tree in transport situation;

— to move to the place of change of tree and to lower operating part in hole, to pull out lobes and to clean ladle.

At arrangement of the replaced tree at a great distance from the place of landing to use special containers for landing.

For ensuring stability of the machine when grubbing and landings tree are used sliding support.

Optimal 2000
Upper diameter of the block of the cm cutting lopat196
Depth vyemki126 cm
Worker vysota267 cm
Width at closed rame220 by cm
Width at opened rame320 by cm
Width between open shutters ramy170 cm
Inside diameter ramy140 cm
Deadweight mashiny3800 kg
Quantity lopat4
The volume of the block of the m cutting lopat1,90 ³